Correct operation method of straw baler

The straw baler equipment has been extremely hot in recent years. On the one hand, the state has banned straw burning, and on the other hand, the vigorous promotion of straw recycling has also enabled more and more customers to understand the advantages of straw baling equipment. The straw baler equipment is a tool for recycling corn stalks, bean stalks and other agricultural and forestry wastes into high-quality straw coal by recycling and crushing, and after years of development, the straw baler equipment has a complete operation equipment, that is, It is said that it is not necessary to separately equip the pulverizer to directly pulverize and mold, which provides more convenience for the producer, but the investor can't pay attention to its maintenance and maintenance because of the excellent performance of the equipment itself, and wants the straw baler to keep it. Excellent production performance requires operators to learn professional equipment operation methods. The following are the professional manufacturers of Qufu Xinyang Machinery Technology Co., Ltd. to explain these methods in detail, and hope to help investors:

1. Please inject 25 kg of gear oil before starting the machine (you can use it continuously for more than 10 years), and tighten the oil plug after refueling.

2. Carefully check the power lines to prevent the affected points and leakage, and ensure that the level is safe.

3. Carefully check the bolts of the machine motor and the connecting parts of the transmission parts, whether the screws can be consolidated, whether there is looseness or not, so as to be fastened in time.

4. Set the preheating temperature according to the species of the species. Corn and wheat straw are between 80 degrees Celsius and 90 degrees Celsius, and peanut shell rice husks are between 80 degrees Celsius and 100 degrees Celsius.

5. After starting the machine, first idle for 1 minute, check whether the machine can rotate normally. When it is normal, feed it in a small amount. After the remaining material in the standby device is cleaned, the average feeding can be performed.

6. Before loading, please be sure to pay attention to the hard materials in the raw materials, and remove the stone and iron blocks into the silo to avoid damage to the machine.

7. For every 8 hours of operation, you must refuel the oil filling on the universal joint once, and apply 2-3 drops of oil at a time. Please put a little wet material before stopping, so that it can be discharged smoothly after the next day.