The main principle by filtration through centrifugal force centrifuge (with appropriate filter) produced by high speed centrifugal drum, the solid-liquid mixture to accelerate thrown drum, and the drum will remain in the solid phase Inside, the effect of separating solids and liquids, or the effect of dehydration, is achieved. The main principle of the decanter centrifuge is to accelerate the sedimentation velocity of different specific gravity components (solid phase or liquid phase) in the mixture by the powerful centrifugal force generated by the high-speed rotation of the rotor, and to separate the different sedimentation coefficients and buoyant density substances in the sample. Lacto Helveticus,Lactobacillus Helveticus,Lactobacillus Helveticus Powder,Lactobacillus Helveticus Probiotic Jiangsu Biodep Biotechnology Co. ,Ltd. , https://www.mbioda.com
　　
The heat dissipation of the normal centrifuge is very good, generally there is no problem (except for some manufacturers). However, in some cases, some centrifuges have abnormal heat dissipation. The main reasons are as follows:
　　
1. The fan of the centrifuge is blocked by cotton cloth, etc., and the heat cannot be dissipated normally. Operation: Please check the fan port. The centrifuge produced by Xiangzhi has a heat dissipation port. The vents of the desktop are shown in the figure.
　　
2, the fan is broken, do not turn, check: put the hand to the fan port to see if there is a fan out. If there is no wind, please check if the fan's power cord is normal or replace the fan.
　　
3. The power setting of the centrifuge is too high, far exceeding the actual power, and the excess power is converted into heat energy. Action: Set the centrifuge parameters.
　　
4. Centrifuge setting or starting device problem, the energy conversion rate is lower when the centrifuge is started. If the centrifuge is set too fast or there is a problem with the starting device, it is easy to make the centrifuge power too large, but the energy conversion rate is low and the case is overheated. Excessive heat of the centrifuge components will greatly shorten the use time of the centrifuge components, and the cause of the centrifuge failure should be found and processed in time. Or contact the centrifuge manufacturer for centrifuge troubleshooting.
　　
5. The centrifuge is overloaded, so that the current becomes larger, the rated power is greater than the actual power, and the excess is converted into heat dissipation, which causes the centrifuge components to overheat. Operation: Carefully read the centrifuge's practical instructions.
　　
6, Li Xin Jian centrifuge to remind the majority of users to buy regular manufacturers of products, in order to avoid some problems caused by centrifuge safety problems.