The biological microscope XSP-8CA is used to observe and study biological sections, biological cells, bacteria, and living tissue culture, fluid precipitation, etc., while observing other transparent or translucent objects as well as objects such as powders and fine particles. In order to ensure the stability of the biological microscope XSP-8CA during use, the user needs to perform necessary maintenance and maintenance on the equipment regularly, including: 1. Place the biological microscope XSP-8CA in a dry and clean room to avoid mold, metal parts and dust. After the microscope is used, put it back in the box (cabinet), or cover it with a glass cover, plastic cover, and put in the dry agent. 2. The biological microscope XSP-8CA should not be placed together with corrosive acids, alkalis or volatile chemicals to avoid corrosion and shorten the service life. In principle, when observing a liquid-containing specimen, it is usually covered with a cover slip; if the liquid contains corrosive chemicals such as acid or alkali, the perimeter of the coverslip should be sealed with paraffin or vaseline, and then observed. . However, due to the microscopic identification of traditional Chinese medicines, it is often necessary to use such reagents, and it is impossible to seal them. Therefore, special care should be taken to prevent liquid from flowing onto the stage and not to be exposed to the objective lens. 3. The biological microscope XSP-8CA should not be exposed to direct sunlight, nor should it be placed close to the stove or the heating to avoid the degumming, deformation or damage of the lens and the parts caused by the sudden change of heat and cold. Limited to the outer surface. After the surface of the object is contaminated with the drug, wipe it with a small amount of mirror liquid (do not use ethanol); if the back side should be cleaned, wipe it with a soft brush or use a leather tip to remove dust. 4. Do not disassemble the parts by yourself; insert the eyepiece or the cover of the lens to prevent the dust from entering from the upper part of the lens barrel; do not touch or wipe the surface of the lens with dust. If there is dust, use a soft brush first. Gently rub it, then wipe it with a soft, clean cloth. You can also use a pair of xylene or petroleum fans to wipe the paper, but be careful not to scratch the lens surface. If the lens has mild mildew, if it can't be wiped with the paper, use a cotton swab to gently wipe the mixture with a little 70% ethanol and 30%. 5, after using the oil mirror, the cedar oil on the lens must be wiped clean (can be wiped with a little xylene with a mirror paper, but the xylene can not penetrate into the lens, otherwise the xylene dissolves the adhesive between the lenses The lens can be detached. The mirror surface should be protected from cleaning. Do not allow water, xylene or cedar to penetrate, so as to prevent the mercury from falling off the mirror. 6, biological microscope XSP-8CA plus mechanical parts are not flexible, can be used fine silk cloth xylene less sputum: wipe rust and greasy (do not use ethanol, because these solvents will erode paint), and then use a little liquid stone clothing lubrication; Twist tightly and do not twist forcibly to avoid damage. 7. Sometimes there are stains or foreign objects found in the field of view of the biological microscope XSP-8CA. You can rotate the eyepiece first. If the stains follow the rotation, you can confirm that the stain is on the eyepiece; otherwise, the specimen can be moved, such as stains, to move. Then the stain is on the specimen. If neither is, the stain is on the objective lens. You can first lick the front lens of the food mirror and then check the rear lens. Clean up according to the situation. Cleaner Products,Toilet Bowl Cleaner Liquid,Toilet Block Cleaner,Stain Remover Cleaning Wuxi Keni Daily Cosmetics Co.,Ltd , https://www.wxkenidaily.com Stability of the use of biological microscope XSP-8CA