Fire Alarm By Room,Smoke Alarm By Room,Room Smoke Alarm,Room Smoke Alarms Guangdong Isafenest Co.,Ltd. , https://www.isfenest.com
application
Three-dimensional motion mixers are widely used for drying and mixing dry powder mortar, chemicals, pesticides, detergents, pigment foods, monosodium glutamate, milk powder, salt, feed, chemicals, ceramics, plastics, rubber additives and other powders.
It requires that all materials involved in mixing evenly distributed when the mixer performance <br> <br> three-dimensional movement. The degree of mixing is divided into three states: ideal mixing, random mixing, and completely unmixed. The degree of mixing of the various materials in the mixing machine depends on factors such as the proportion of the material to be mixed, the physical state and characteristics, and the type of mixing machine used and the duration of the mixing operation.
Categories <br> <br> powder mixer commonly used are: ploughshare mixer, a ribbon mixer, an intensive mixer, weightlessness mixer, cone mixer like double helix.
Use and maintenance 1, installation: the machine is placed smoothly, the machine feet are installed, the level is flat, so that the mechanical energy can run freely. 2. Before use, add oil to the oiling station, then carry out no-load operation, check whether the fasteners are loose, whether the electrical is normal, whether the machine is working properly, and if there is any abnormality, carry out renovation and debugging. 3. Turn the feeding port to the top, open the feeding cover for feeding, the feeding amount should not exceed the specified volume, then close the feeding cover, start the machine to run, if abnormality is found on the way, it must be stopped for inspection. 4. After work or after changing the variety, the inside and outside of the hopper must be rinsed clean.
Evaluation of the quality of the mixer:
A. Uniformity: Analyze the physical quantity of materials involved in good or bad, obtained by probability theory, and the mixing uniformity is determined by the type of mixer. B. Dead angle: refers to the physical phenomenon that the material can not participate in mixing in the mixing container. The percentage of dead angle is the physical quantity for evaluating the quality of the mixer. C. Mixing time: The physical quantity for evaluating the mixing speed, which refers to the time when different materials start to mix until the mixing reaches the uniformity requirement. The mixing time is determined by the type and model of the mixer.
3D motion mixer application and use and maintenance
The three-dimensional motion mixer is a machine that uniformly mixes two or more kinds of powder materials by mechanical force, gravity, or the like. The 3D motion mixer can mix a variety of materials into a homogeneous mixture; it can also increase the contact surface area of ​​the material to promote chemical reactions; it can also accelerate physical changes, such as the addition of particulate solutes to the solvent, and accelerate the dissolution and mixing by the action of the mixing machine.