1. Maintenance and maintenance of the experimental centrifuge :

1. Clean the rotor chamber and rotor with water or a mild detergent. Do not use alkaline solution or solvent that is abrasive to the material. Wash with clean water and dry the chamber with a dry cloth.

2. Open the top cover when the centrifuge is not in use, keep the rotor chamber dry to avoid motor bearing wear.

3. Use a rag or tweezers to remove debris from the rotor chamber.

4. Special safety measures must be taken when centrifuging toxic, radioactive, and contaminated samples.

2. Maintenance methods for medical centrifuge accessories:

1. The centrifuge should keep a certain distance from other electrical equipment, and have good grounding measures, and conduct regular inspections.

2. Centrifuges and rotors must not be exposed to high levels of UV radiation or for extended periods of time. Apply a neutral detergent when cleaning.

3. The rotor can be replaced if needed. After reinstallation, tighten the turnbuckle screws.

4. If there is a centrifuge tube, the color change, deformation, leakage, etc. must be stopped.

5. Do not screw on the cap when performing high temperature and high pressure sterilization on the centrifuge tube to avoid deformation of the tube. See the section of this user manual for the temperature tolerance of each centrifuge tube.

3. Maintenance method of medical centrifuge condenser:

1. The condenser is used to cool the refrigerant and is installed at the rear of the centrifuge, using air cooling.

2. The condenser should be cleaned of dust regularly to avoid heat transfer. It can be purged here with compressed air.

4. Maintenance method of the rotary pin of the medical centrifuge: the rotary pin should be lubricated with lubricating oil to ensure the smooth operation of the centrifuge.

5. Sterilization and disinfection methods for medical centrifuge rotor chambers and accessories: All conventional disinfectants can be used. Since the centrifuge and accessories are made of different materials, the compatibility of the disinfectant must be considered.

6. The centrifuge of the medical centrifuge should ensure that the important parts of the centrifuge are intact, mainly: the motor suspension is stable, the rotor and accessories are not corroded, the shaft is not deviated, the screw connection is fastened and the grounding is good.