If the baler is not properly operated during use, it will not only delay the working hours, but also may cause danger. Therefore, it must be used in strict accordance with the operating principles. 1. The connection between the host and the baler. The limit arm should be connected properly. If it is too loose, it will not be able to bend. The limit arm can easily grind the rear tire of the main machine. The swing amplitude is too large, and it is easy to cause damage to its own parts. It is too tight and the corner angle is increased. It is also easy to ruin the grass when the ground is turned. 2. The ropes are not inserted. First check if the rope is entangled due to quality problems, for example: the knot is too large, the hair is too large, and then check the density of the knot at the entrance of the rope (left). If the density is not high enough, the friction between the rope and the knot is not enough. Large, then you can eat more grass on the left side of the baler to increase the friction at the entrance of the rope and promote the rope feeding. 3. The adjustment of the bales is easy to disperse. When the wheat section has a large humidity, it is easy to pick up and bundle, and the low-density hole can be adjusted. When the wheat section is dry and fragile, it is difficult to pick up the feed, and the density hole should be adjusted. It is also possible to bundle the straw by adjusting the number of turns of the rope. Dry wheat straw, increase the number of turns, wet wheat straw, reduce the number of turns. 4. Adjustment of the number of ropes. Adjusted to the big wheel, the number of ropes is more, 10 ropes; transferred to the small wheel, the number of turns is less, 7 ropes. 5. The length of the rope is appropriate, so that the rope head just touches the blade. 6. The reason why the protection screw is broken. When the baler is full of wheat, the alarm does not alarm, the wheat section will be piled up at the entrance, and if it continues to walk, it will cause the protection screw to be broken. 7. The reason why the alarm port does not alarm. (1) The power supply is not connected, (2) the wire is disconnected, and (3) the circlip handle is removed from the handle groove. 8. The rope should be broken continuously, and the blade should be replaced because the blade is blunt. 9. During the process of picking up the grass, the driving speed of the power machine can be slightly faster. When the small four wheels are driven, the 2-speed gear is suitable. 10. Equipped with consumables. Protective screws and blades should be equipped with grass to avoid delays in working hours. (Yi Yao) FOSHAN PHARMA CO., LTD. , https://www.full-pharma.com
Ten technical essentials for baler operation
Tag: baler